Contents
Item | Qty | Description |
A | 1 | End seal assembly |
B | 1 | Cable Lubricant |
C | 1 | End seal label |
D | 1 | Cable tie |
This Kit may be installed at temperatures as low as -40℃.
- Wire cutters
- Utility Knife
- slotted screwdriver or Nutdriver
- Pipe strap
- CM-ESS-0 Jacket patch kits
1.∙Allow approximately 24”(60cm) of heating cable for installation.
∙Cut off heating cable end at about 45° for easier insertion.
2.∙Push 12”(30cm) of heating cable through stand.
∙Use cable lubricant if needed.
3.Optional :
∙Lightly score outer jacket around and down as shown.
∙Bend heating cable to break jacket at the score, then peel off jacket.
∙Remove all exposed braid.
4.Pull heating cable back through bottom of end seal stand until braid is just visible above strain relief.
∙. Use cable lubricant if needed.
5.∙Push boot onto the end of the heating cable until it bottoms out.
CAUTION :Health Hazard. Wash hands after contact with sealant.
6.∙Fasten end seal to pipe with strap.
∙Do not pinch heating cable.
∙Install cable tie.
∙Loop and tape extra heating cable to pipe
Apply insulation and cladding.
∙Fasten end seal label to insulation.
1.∙Turn off power.
∙Clip cable tie and remove.
2.CAUTION :∙Unscrew cap from end seal stand.
3.∙Grab black ring and remove boot.
CAUTION :Health Hazard. Wash hands after contact with sealant.
4.∙Test
5.∙Inspect boot.
∙If boot is damaged or sealant appears dry or missing, replace boot or re-install boot.
6.Install cap : tighten until the slot on the cap and the slot on the stand align.
∙Install new cable tie